The drip edge is nailed in place using 1-1/2 galvanized roofing nails. a felt-tip marker works great for marking cuts. and, again, prying open the end with a small flat bar allows the pieces to overlap cleanly.. Install the new drip edge. the final discussion of how to install drip edge involves the 7 steps directly focused on the drip edge installation phase. the previous mentions of the necessary tools, equipment, and method of removing the old drip edge will help make these steps go smoothly. begin by installing the drip edge across the lower roof edge.. Install the drip edge by fitting it on the roof eave, pushing it tightly against the edge of the plywood and nailing or screwing it down. use 1-inch galvanized roofing nails or 3/4-inch exterior screws. space the fasteners by about 12 inches. overlap two pieces of flashing that meet end to end by at least 1 inch..
Drip edge installation on an existing roof. december 26, 2017 at 7:05 paul begins replacing the drip edge roof flashing. use a flatbar to remove drip edge nails along the eave and rakes. make sure to tuck the drip edge under the starter strip and felt paper.. How soffits and fascia are rotted and ruined - promaster home repair - duration: 9:49. promaster home repair & handyman of cincinnati 220,225 views. On gable roofs, install ice and water shield and felt paper all the way up the gable to the ridge, then work up the ridge with drip edge, laying it on top of the ice and water and the felt. this is so that if water were to happen to get underneath the shingles at the gable end, it would not get past the underlayment..